Crane firm issues statement following HSE fine

17 August 2010

Print Page

London Tower Crane Hire & Sales Limited has issued a statement after being fined £18,000 and ordered to pay £15,837.45 by the UK’s Health & Safety Executive (HSE), following an accident, which resulted in a 4t load crashing to the ground.

A hook broke off a tower crane and caused the load to fall 36m during construction work at Hertfordshire Regional College in Turnford on 3 November 2007. The load damaged a college building and demolished the site boundary fence when it fell next to a frequently used walkway.

Hertford Magistrates Court ruled the firm breached Section 3(1) of the Health and Safety at Work etc Act 1974, Regulation 5(2) of the Construction (Design and Management) Regulations 2007 and Regulation 8(1) of the Lifting Operations and Lifting Equipment Regulation 1998.

HSE Inspector Norman Macritchie said: “It was a matter of good fortune that no-one was injured in this entirely avoidable incident. Those undertaking lifting operations have absolute duties to plan, supervise and carry them out safely. Maintenance staff had identified safety-critical faults in the crane yet simple controls needed to prevent use of defective equipment were not implemented.

“Poor communication and teamwork, together with inadequate supervision, all contributed to this incident. This case has important lesions for all those operating lifting equipment and especially tower cranes.”

London Tower Crane Hire & Sales Limited, operations director Martin Harvey told Cranes Today: “In response to this incident we have implemented dynamic and robust safety systems addressing the specific failings of this incident and wider risks across our operations.

“We welcome the comments from the HSE and have continually strived since this incident in cooperation with the executive to learn these critical lessons.

“We are satisfied that the circumstances which contributed to this incident in November 2007, no longer exist within our business and that our systems and procedures are currently industry leading.”